NASA’s Curiosity rover continues to explore the Martian surface, approaching an area called “Yellowknife Bay,” which is a potential location for selecting the first target rock for Curiosity’s hammering drill, bringing the mission’s total driving distance to 598 meters.

Pasadena, California — The NASA Mars rover Curiosity drove 63 feet (19 meters) northeastward early Monday, Dec. 10, approaching a step down into a slightly lower area called “Yellowknife Bay,” where researchers intend to choose a rock to drill.

The drive was Curiosity’s fourth consecutive driving day since leaving a site near an outcrop called “Point Lake,” where it arrived last month. These drives totaled 260 feet (79 meters) and brought the mission’s total odometry to 0.37 mile (598 meters).

The route took the rover close to an outcrop called “Shaler,” where scientists used Curiosity’s Chemistry and Camera (ChemCam) instrument and Mast Camera (Mastcam) to assess the rock’s composition and observe its layering. Before departure from Point Lake, a fourth sample of dusty sand that the rover had been carrying from the “Rocknest” drift was ingested and analyzed by Curiosity’s Sample Analysis at Mars (SAM) instrument.

Curiosity ended Monday’s drive about 30 percent shorter than planned for the day when it detected a slight difference between two calculations of its tilt, not an immediate risk, but a trigger for software to halt the drive as a precaution. “The rover is traversing across terrain different from where it has driven earlier, and responding differently,” said Rick Welch, mission manager at NASA’s Jet Propulsion Laboratory, Pasadena, Calif. “We’re making progress, though we’re still in the learning phase with this rover, going a little slower on this terrain than we might wish we could.”